MetalMaster HG3208VR, Руководство пользователя

Страница: 21 / 24

QC11Y Hydraulic Guillotine Shear
19
beam will move down to the dead center. Inspect the nitrogen pressure by
accumulator nitrogen tool. If the nitrogen pressure is less than 5~6 Mpa, pls fill in.
After inspection and the filling, pls follow up the oil filling procedures
（
5.7
）
CAUTION: ONLY FILL IN THE NITROGEN INSIDE THE ACCUMULATOR,
OTHERS ARE STRICTLY PROHIBITTED
8.4 The maintenance of the hydraulic system
8.4.1
The ruturn lines(return circuit) of hydraulic system
1） check the oil level of the oil tank. If the oil level is less than the middle line, pls
fill in the oil immediately up to the middle line.
2
）
After the machine has been run for one month, pls change the oil for the first
time.
3
）
Pls change the oil every 2000 hours of operation.
4
）
The hydraulic oil should be qualified and the viscosity is 27-33.
5
）
Pls clean the oil tank thoroughly for every oil changing
8.4.2
Oil filter
1
）
Use gasoline or other solution to clean the oil filter. Pls refer to below timeline to
clean the filter: Clean the filter first time after 8 days of machine formal operation.
And later clean the filter every 30 days of operation.
2
）
Pls change the components of filter if they are found to be damaged.
8.4.3 Air filter
1
）
The air filter is installed at the oil tank.
2
）
Pls clean the filter first time after 500 hours of machine formal operation. Use
gasoline or chloroethylene or other solution to clean it. And clean the filter every
1000 hours of operation.
8.4.4
Hydraulic pump
Pls refer to relevant technical data of hydraulic pump.
8.4.5
The inspection of the mechanical parts:
Pls check the fittings once a week for the tightness and also check the lubrication