Metacon-Next B.V.
OHD-C EI(1) 60 / EI(2) 90 / EW 90 & OHD-C EI(1) 120
18-07-2022
User manual
art nr: 89022
Rev: 4
19
Step 5a - preparation for drive shaft assembly
Degrease and oil the axle journals before mounting the bearings on them.
Slide the safety brake over the axle journal by rotating in the right direction with key.
PLEASE NOTE: Check that the safety brake is not blocked. If it is blocked, it must be
unblocked! See safety brake on data sheet for further instructions.
Place the bearing over the axle journal on the other side.
Tighten 1 locking screw of the bearing by hand to prevent it from sliding off.
Note: The figure below refers to a situation where the drive is located on the left.
Step 5b: Mount the sprocket
On the motor side, insert the key into the axle journal. Then slide the sprocket on with the
hub pointing in the opposite direction of the roll.
