Metabo W 20-230 SP, Инструкция по эксплуатации

Страница: 15 / 116

Installing protective hood on W 20-230 SP,
W 25-180:
(for working with abrasive discs)
Mount the protective hood on the machine neck
(align cams with recesses). Align the protective
hood if necessary and tighten the securing screw
firmly with a screwdriver.
The securing screw on the protective
hood must always be firmly tightened.
Handle
Press in button (7). The handle can now be turned
by 90° to both sides and engaged.
Important! Work only with the handle
engaged
Connect to mains supply.
8 Operation, Switching On/Off
Always guide the machine with both
hands!
First switch on, then apply the tool to
the work piece!
It must be avoided that the machine
draws in additional dust and shavings.
When switching the machine on and off,
keep it away from dust deposits.
After switching off the machine, only
place it down when the motor has come
to a standstill.
Switching the angle grinder ON just for a
moment:
Press the safety lock button (2).
Push the start / stop lever (1).
Release the safety lock button (2).
To switch OFF, release the start / stop lever (1).
Switching the angle grinder ON for a longer
period (depending on equipment):
Press the safety lock button (2).
Push the start / stop lever (1) and then release
again.
Release the safety lock button (2).
To switch OFF, push the start / stop lever (1) and
then release again.
If switched on continuously, the
machine continues running if it is jerked
out of your hands. Therefore, always
hold the machine with both hands on
the handles, stand safely, and
concentrate on your work.
9 Operation, Fitting Tools
Before any tool changing operation,
always remove the plug from the mains
supply socket and check that the angle
grinder is switched off and that the
spindle has come to a halt.
The spindle lock button (6) may only be
pressed when the spindle is completely
stationary ! (Failure to observe this
instruction may damage the gear system)
Locking the spindle
Press in the spindle-lock button (6) and turn the
spindle by hand until the spindle-lock button can
be felt to engage in position.
2 1
15
ENGLISH
02 ENG_WS_Schur_0407 08.11.2007 13:48 Uhr Seite 15