12.13.3
Port, 802.1p, IP/DS based
The page allows you to enable Port Based, VLAN Tag or IP/DS mode of COS.
Figure 6-2
Class of Service Configuration
=Enable High Priority. After Enabled High Priority, the following
enabled Port Based parameter will become High Priority.
Port Base:
The selected port equipped with High Priority. The
non-selected port is Low priority. A packet received by a high priority
port is handled as a high priority packet.
VLAN Tag:
The switch follows the VLAN tag of the incoming packets
to forward traffic. VLAN Tag priority: high priority -> 4~7 ; low priority ->
0~3
IP/DS:
The switch follows the IP TOS / Diff Serve of the incoming
packets to forward traffic. Ipv4 DS and Ipv6 TC: high priority ->
10,18,26,34,46,48,56 ; low priority -> others
12.13.3
TCP/UDP Port Based
This page allows user to define the Option type of the pre-defined protocols or
user-defined protocols. Select the Option of the Protocol as below figure
shown.
33
