MesaPhotonics VideoFROG FROGscan, Руководство пользователя

Страница: 54 / 71

Chapter 6. Installing and Changing Hardware
Page 48 FROGSCAN USER’S MANUAL 09/07/2018 Vs 003
Kinematic mount that fits in the Thorlabs cage rod
system, adapter, and a fiber collimator. 4. Install four (4) Cage Assembly Rods to the
4-40 tapped holes surrounding Entrance
Iris.
5. Secure the Kinematic Mount to the Rods by
tightening the set-screws on both sides of the
Kinematic Mount. Set the relative position of the
adjusters so they are approximately 3mm from the
Side Plate of the FROGscan. The Adapter is installed in the mount at the
factory. It is secured in place with two retaining
rings and mounted such that one of the retaining
rings is as close to the front of the mount as
possible. Please do not change the positions of
the retaining rings or adapter.
6. Tightly push the Adapter Ring against the
Collimator Ring. 7. Fully install the Collimator in the Kinematic
Mount. Be sure to set the correct orientation
for the angled part of the Collimator such
that the fiber can be easily installed when
the Assembly is mounted on the
FROGscan.