Chapter 2. Setup
Page 4
FROGSCAN USER’S MANUAL
09/07/2018 Vs 003
Chapter 2. Setup
2.1 Inspecting the FROGscan Shipment Contents
Inspect the contents of the FROGscan box, which contains the following:
1.
FROGscan Device.
2.
Power Supply, Power Cable and Mini XLR Power Supply plug.
3.
2 USB Cables (for the Spectrometer and Servo Motor).
4.
Tools: 5/64” Hex-L-Key, 4 mm Hex-L-Key (FROGscan Ultra), 3 mm Hex-L-Key (FROGscan
standard).
5.
Computer (optional) with preloaded VideoFROGscan Software.
OR
6.
USB Flash drive with preloaded VideoFROGscan Software.
7.
FROGscan Manual.
8.
FROGscan Quick Setup Guide.
9.
Calibration sheets and Warranty Information appended in the FROGscan Manual.
2.2 Setting up FROGscan
The servo motor and crystal have been secured for shipping and must be released before use.
PLEASE READ THESE INSTRUCTIONS CAREFULLY TO AVOID DAMAGE TO THE
INSTRUMENT
Always wear powder-free gloves when manipulating components within FROGscan.
1.
Remove the anti-static covering from FROGscan and place the unit in the approximate desired
location on the optical table.
2.
Open the FROGscan cover by twisting the two captive thumb screws on the base of the hinged
cover. Carefully lift the cover up until it remains in the upright position.
3.
Remove the foam cushion from the beam block.
To free the servo:
4.
CAREFULLY release the Servo Motor (see
Figure 1
for the location of the Servo) by removing the
tape and the white
REMOVE
label along with the yellow tipped servo clip. Carefully place one
fingertip on top of the servo motor and verify that the Servo Stage moves freely.
Содержание VideoFROG FROGscan
Страница 1: ...FROGscan products are protected by United States patents 8068230 7130052 6219142...
Страница 2: ......
Страница 4: ......
