Mesa Labs Smart-Well Model 1710 Operation Manual - 9153 Rev E
7
UNPACKING AND INSPECTION
1.
Remove all contents from the box and carefully inspect all components for any damage that
may have occurred in transit. If any damage is observed, notify your Mesa Labs representative
immediately.
2.
Verify that the following components have been included in the kit:
•
Smart-Well incubator
•
Smart-Well multinational
power pack kit
•
Printer kit including printer, manual, 7V power pack (input voltage 110 or 220), plug adapter
for power pack (optional), one roll of paper, and one printer ribbon
•
Printer cable
•
Smart-Well Incubator Manual
PRINTER SETUP
Prior to operating the printer, refer to the
warnings and considerations in the printer
manual.
PRINTER SETTINGS
To communicate with the 1710 Incubator, the Printer must be set to communicate at 4800 baud, 8 bits,
no parity. There are eight numbered switches located in the bottom of the Paper cavity. Verify the
switches are set as indicated below:
1 – OFF
2 – OFF
3 – ON
4 – OFF
5 – OFF
6 – OFF
7 – OFF
8 – OFF
CONNECTING AC POWER
1.
Ensure that the power switch on the side of the printer is in the
OFF
position.
2.
Insert the small connector from the printer power pack into the matching receptacle in the back
of the printer. Note: Plugging the incubator power supply (Smaller power supply) cable into the
printer may cause damage to the printer.
