Storing and Overwriting a Route
A route can be stored from any mode by pressing the
route record
button. The
trolling motor will emit a tone when the
route record
button is pressed. Once
the
route record
button is pressed, begin navigating along your desired
course. You can switch between manual mode and heading lock mode at any
time while recording a route. The trolling motor will emit one beep (and the
GPS status indicator light will blink) for every 2 m (6.5 ft) travelled while
recording. Press and hold any of the numbered
memory
buttons to stop
recording and store the route to the selected
memory
button. The trolling motor
will emit a tone to confirm that it has stored the route. The trolling motor can
store up to eight routes, each up to 6.4 km (4 miles) in length.
Stored routes cannot be erased, but you can overwrite (record over) them.
Overwriting a stored route is accomplished using the same procedure as
storing a new route.
Recalling a Stored Route
A stored route can be recalled while operating in any mode by pressing the
route playback
button, then pressing the desired
memory
button. The trolling
motor will emit an ascending chirp to indicate that the route has been
successfully recalled.
IMPORTANT: When recalling a stored route, the system will calculate a
straight‑line course from your current position to the nearest point on the
recalled route. Ensure that there are no obstructions to navigation between
your current position and the recalled route. The system will recall a stored
route even if obstructions are present. If obstructions are encountered, navigate
around them by operating in manual mode.
TROLLING MOTOR INSTALLATION AND OPERATION
56
eng