6. Push the pedal into the full heel down position and install the rear screw
on the foot pedal.
a -
Rear screw
b -
Front screws (2)
Bounce Buster Installation
1. Place the trolling motor in the stowed position.
2. Remove the bounce buster from the mounting accessory kit.
!
CAUTION
Avoid injury from parts flying into the passenger compartment of the boat. If
the bounce buster is not correctly installed, the trolling motor can
inadvertently deploy, which at planning speed could result in catastrophic
failure of the trolling motor. Check that the stow latch fully engages after
installation of the bounce buster.
3. Measure the distance between the boat deck and the outside surface of
the mounting bracket.
a -
Distance between the boat deck and the
outside surface of the mounting bracket.
4. Add 12.7 mm (1/2 in.) to the measured length (distance between the boat
deck and the outside surface of the mounting bracket) taken in the
previous step.
a
b
70278
70125
a
TROLLING MOTOR INSTALLATION AND OPERATION
22
eng