Mercury MerCruiser Axius 350 MAG, Руководство пользователя

Страница: 82 / 151

Section 3 - On The Water
Page 74 90-864197084 NOVEMBER 2008
8. If you are not in a previously set waypoint arrival zone, "WAYPOINT SEQUENCE" mode starts auto sequencing to the
waypoints in the route. Acknowledge that you understand the information presented by the pop‑up screen warning and press
the enter button—the button with a check mark symbol.
31412
Pop-up screen warning
9. Press the "TRACK WAYPOINT" button. The "WAYPOINT SEQUENCE" button light turns on and a single horn beep sounds.
10. Press the "TRACK WAYPOINT" button a second time to put Axius Premier in Standby mode. All lights other than "STANDBY"
turn off.
Cruise Control
The VesselView system features integrated throttle cruise control (cruise), which allows the operator to limit the peak RPM of
choice below Wide Open Throttle (WOT). This feature requires VesselView. Refer to the owner's manual provided with your
VesselView for operation instructions.
These additional notes are exclusive to your package:
•
You can change or disengage cruise through the screen at any time.
• Cruise resets when the key is turned off.
• If the cruise limit is changed while the levers are at WOT, cruise gradually changes to the new speed.
• Cruise does not disengage if the ERC levers are at a higher engine speed than the actual RPM. Bring the levers back to the
forward detent to disengage.
Contingent Operations
Port Engine Only Operation
The force feedback feature of the steering wheel is only available when the starboard key switch is in the on position. If the starboard
key switch is off or there has been damage to the starboard electrical system, the port control system monitors the steering wheel.
If only the port side is operational, or only the port key switch is in the on position, the force feedback system will not provide end
stops for the steering wheel. In this case, the drive will turn in the direction of steering wheel rotation until the mechanical limits of
the drive are reached.
NOTE: If the port electrical system is damaged, the steering wheel will operate normally with complete force feedback and end
stops.
Note that joystick is not available in single‑engine operation. However, Axius features redundant track pad systems, so Auto
Heading mode is still available during single‑engine operation.