Mercury 6.2 TowSport MPI, Руководство по эксплуатации и обслуживанию

Страница: 54 / 87

Section 4 - Maintenance
Page 46 90-8M0128975
eng
JUNE 2017
b. If not equipped with a seacock, disconnect the seawater inlet hose from the transmission seawater inlet fitting and
plug the seawater inlet hose.
58419
45IV shown, 46IV similar
c. Install an appropriate connector attached to the fresh water supply hose and install the connector onto the
transmission seawater inlet fitting.
d. Proceed to step 3.
2.
All other models:
a. Close the seacock, if equipped, and then disconnect the seawater inlet hose from the seawater pump inlet fitting.
b. If not equipped with a seacock, disconnect the seawater inlet hose from the seawater pump and plug the hose.
55049
Seawater inlet hose connection
c. Install an appropriate connector onto the flushing water supply hose and install onto the water inlet of the seawater
pump.
d. Proceed to step 3.
NOTICE
Flushing the engine when it is not operating will result in water collecting in the exhaust system, damaging the engine. Do not
supply flush water for more than 15 seconds without the engine operating.
3. Open the water source to provide maximum water supply.
4. Place the remote control in the neutral idle speed position.
5. Immediately start the engine.
NOTICE
Operating the engine out of the water at high speeds creates suction, which can collapse the water supply hose and overheat
the engine. Do not operate the engine above 1400 RPM out of the water and without sufficient cooling water supply.
6. Press the throttle only button and slowly advance the throttle until the engine reaches 1300 RPM (± 100 RPM).
7. Observe the water temperature gauge to ensure that the engine is operating in the normal range.