Mercury 6.2 TowSport MPI, Руководство по эксплуатации и обслуживанию

Страница: 39 / 87

Section 4 - Maintenance
90-8M0128975
eng
JUNE 2017 Page 31
2. Remove the dipstick, wipe it clean, and install it fully into the dipstick tube. Wait 60 seconds to allow trapped air to vent.
Remove the dipstick.
58400
V-drive model shown
58402
In-line drive model shown
3. Inspect the dipstick for the oil level reading. The oil should be between the ADD mark and the FULL or OK range mark on
the dipstick. Install the dipstick into the dipstick tube. If the oil level is low, refer to
Filling
.
Oil Level—Overfilled
IMPORTANT: Do not overfill the engine with oil. An overfilled crankcase can cause a fluctuation or drop in oil pressure and
rocker arm clatter, and result in a loss of engine performance.
An overfilled crankcase (oil level too high) can cause a fluctuation or drop in oil pressure, and rocker arm clatter. This condition
results in the engine crankshaft splashing and agitating the oil, causing it to foam (become aerated). The aerated oil causes the
hydraulic valve lifters to bleed down. This results in rocker arm clatter and loss of engine performance.
Care must be taken when checking the engine oil level. The oil level must be maintained between the ADD mark and the FULL
or OK range mark on the dipstick.
Filling
IMPORTANT: Do not overfill the engine with oil. Always use the dipstick to determine the exact quantity of oil or fluid required.