Mercury 6.2 TowSport MPI, Руководство по эксплуатации и обслуживанию

Страница: 47 / 87

Section 4 - Maintenance
90-8M0128975
eng
JUNE 2017 Page 39
c. Lift up on the front of the second cover to disengage the cover from the front grommets. Pull the cover towards the
front of the motor to remove it from the two rear grommets.
a - Front grommets
b - Rear grommets
2. Loosen the clamp securing the flame arrestor and remove the flame arrestor.
Flame arrestor
a - Clamp securing the flame arrestor
b - Flame arrestor
3. Cut the cable tie securing the crankcase vent hose to the flame arrestor and gently pull the vent hose off the flame arrestor.
61330
4. Clean the flame arrestor with warm water and a mild detergent.
5. Inspect the flame arrestor for holes, cracks, or deterioration. Replace if necessary.
6. Allow the flame arrestor to air dry completely before use.
7. Install the vent hose and secure with a cable tie.
8. Install the flame arrestor and tighten the flame arrestor clamp to the specified torque.
Description Nm lb‑in. lb‑ft
Flame arrestor clamp 6.2 55 –
9. Install the engine covers.
a a
b
b
b
63786
61328
a
b