Mercury 6.2 TowSport MPI, Руководство по эксплуатации и обслуживанию

Страница: 55 / 87

Section 4 - Maintenance
90-8M0128975
eng
JUNE 2017 Page 47
8. Operate the engine in neutral for at least 10 minutes.
9. Slowly return the throttle to the idle speed position.
10. Stop the engine.
11. Immediately shut off the supply water and remove the flushing attachment.
12. Install the water inlet hose to the seawater inlet of the seawater pump or 45IV transmission water inlet.
13. Tighten the hose clamps securely.
The Boat in the Water
IMPORTANT: Flushing the power package is most effective when performed with the boat out of the water.
IMPORTANT: Flushing is needed if the engine package has been operated in salty, brackish, mineral‑laden, or polluted water.
For best results flushing is recommended after each outing and before cold weather and extended storage.
NOTICE
Disconnecting the seawater inlet hose will cause water to enter the bilge, resulting in engine damage. Close the seacock
before disconnecting the seawater inlet hose. Plug the seawater inlet hose immediately after disconnecting it.
1.
Models with 45IV or 46IV transmissions:
a. Close the seacock, if equipped, and then disconnect the seawater inlet hose from the transmission seawater inlet
fitting.
NOTICE
Disconnecting the seawater inlet hose will cause water to enter the bilge, resulting in engine damage. Close the seacock
before disconnecting the seawater inlet hose. Plug the seawater inlet hose immediately after disconnecting it.
b. If not equipped with a seacock, disconnect the seawater inlet hose from the transmission seawater inlet fitting and
immediately plug the seawater inlet hose to prevent water from siphoning into the engine or boat.
58419
45IV shown, 46IV similar
c. Install an appropriate connector attached to the fresh water supply hose and install the connector onto the
transmission seawater inlet fitting.
d. Proceed to step 3.
2.
All other models:
a. Close the seacock, if equipped, and then disconnect the seawater inlet hose from the seawater pump inlet fitting.
NOTICE
Disconnecting the seawater inlet hose will cause water to enter the bilge, resulting in engine damage. Close the seacock
before disconnecting the seawater inlet hose. Plug the seawater inlet hose immediately after disconnecting it.