Mercury 200 OptiMax Jet Drive, Руководство по обслуживанию

Страница: 121 / 391

Charging and Starting System
Page 2B-10 90-8M0050731 MAY 2011
Battery Precautions
!
WARNING
An operating or charging battery produces gas that can ignite and explode, spraying out sulfuric acid, which can cause severe
burns. Ventilate the area around the battery and wear protective equipment when handling or servicing batteries.
When charging batteries, an explosive gas mixture forms in each cell. Part of this gas escapes through holes in the vent plugs
and may form an explosive atmosphere around the battery if ventilation is poor. This explosive gas may remain in or around the
battery for several hours after it has been charged. Sparks or flames can ignite this gas and cause an internal explosion, which
may shatter the battery.
The following precautions should be observed to prevent an explosion:
1. Do not smoke near batteries being charged or which have been charged very recently.
2. Do not break live circuits at terminals of batteries, because a spark usually occurs at the point where a live circuit is broken.
Always be careful when connecting or disconnecting cable clamps on chargers. Poor connections are a common cause of
electrical arcs which cause explosions.
3. Do not reverse polarity of battery terminal to cable connections.
Charging a Discharged Battery
!
WARNING
An operating or charging battery produces gas that can ignite and explode, spraying out sulfuric acid, which can cause severe
burns. Ventilate the area around the battery and wear protective equipment when handling or servicing batteries.
The following basic rules apply to any battery charging situation:
1. Any battery may be charged at any rate (in amperes), or as long as spewing of electrolyte (from violent gassing) does not
occur, and for as long as electrolyte temperature does not exceed 52 °C (125 °F). If spewing of electrolyte occurs, or if
electrolyte temperature exceeds 52 °C (125 °F), charging rate (in amperes) must be reduced or temporarily halted to avoid
damage to the battery.
2. Battery is fully charged when, over a 2 hour period at a low charging rate (in amperes), all cells are gassing freely (not spewing
liquid electrolyte), and no change in specific gravity occurs. Full charge specific gravity is 1.260–1.275, corrected for electrolyte
temperature with electrolyte level at 4.8 mm (3/16 in.) over plate, unless electrolyte loss has occurred (from age or overfilling),
in which case, specific gravity reading will be lower. For most satisfactory charging, lower charging rates in amperes are
recommended.
3. If, after prolonged charging, specific gravity of at least 1.230 on all cells cannot be reached, battery is not in optimum condition
and will not provide optimum performance; however, it may continue to provide additional service, if it has performed
satisfactorily in the past.
4. To check the battery voltage while cranking the engine with an electric starting motor at ambient air temperature of 23.8 °C
(75 °F), place the red (+) lead of the tester on the positive (+) battery terminal and the black (–) lead of the tester on the
negative (–) battery terminal. If the voltage drops below 10‑1/2 volts while cranking, the battery is weak and should be
recharged or replaced.
Winter Storage of Batteries
Battery companies are not responsible for battery damage, either in winter storage or in dealer stock, if the following instructions
are not observed:
1. Remove battery from its installation as soon as possible and remove all grease, sulfate, and dirt from the top surface by
running water over top of the battery. Be sure, however, the vent caps are tight beforehand and blow off all excess water
thoroughly with compressed air. Check water level, making sure the plates are covered.
2. When adding distilled water to the battery, be extremely careful not to fill more than 4.8 mm (3/16 in.) above perforated baffles
inside the battery. Battery solution or electrolyte expands from heat caused by charging. Overfilling the battery will cause the
electrolyte to overflow (if filled beyond 4.8 mm [3/16 in.] above baffles).
3. Grease terminal bolts well with 2‑4‑C with Teflon and store the battery in a cool‑dry place. Remove the battery from storage
every 30–45 days, check the water level, and put on charge for 5 or 6 amps. Do not fast charge.
Tube Ref No. Description Where Used Part No.
95
2-4-C with Teflon Battery terminal bolts 92-802859A 1
4. If specific gravity drops below 1.240, check battery for reason and recharge. When gravity reaches 1.260, discontinue
charging. To check specific gravity, use a hydrometer, which can be purchased locally.