Mercia Garden Products 01DTSHRAX1008SDNW-V1, Общее руководство по инструкции

Страница: 5 / 12

P 5
Please retain product label and instructions for future reference
50mm
screw
Pre drill
hole
Step 5
Parts needed - No. 5 QTY 2
No. 6 QTY 2
No. 15 QTY 2
Place the Left Gable and Right Gable
(No.
5 & 6.) together and make sure that they
meet level.
Fix together in the middle using 3x50mm
screws staggering the screws so they do
not collide.
Attach the Ridge Bar Support
(No. 15)
to
the assembled gables using 6x50mm
screws to complete the gable assemblies.
Make sure that the angled edges of the
Ridge Bar Support are flush between the
the inner and outer framing as shown in the
diagram.
Repeat this step for both sets of gables.
18x50mm screws
15
15
5
6
Step 6
Parts needed - No. 2, (or 1, or 3, QTY 1)
No. 3, (or 1, QTY 2)
**Please note: The side panels are all
interchangeable and can be posititioned in
a variety of configurations. Decide which
works best before assembly. See Page 2 for
suggested options.**
Fix the corners of the Large Plain Panel (No. 3)
and a Small Plain Panel
(No. 2)
(or panel of your
choice) with 3x50mm screws as shown in diagram.
Fix the Large Plain Panel
(No. 3)
(or panel of your
choice) to the already standing chosen panel
using 3x50mm screws.
Do not secure the building to the floor until
the roof has been fitted,
Position the panels so there is equal spacing
between the floor and cladding on all sides.
6x50mm Screws
50mm
screw Pre drill
hole
3
3
2
Step 7
Parts needed - No. 2, (or 1, or 3 QTY 1)
No. 3, (or 1, or 2 QTY 2)
Fix the corners of the Small Plain Panel (No. 2)
(or panel of your choice) to the already standing
chosen panel with 50mm screws as shown in
diagram.
Fix the end of the Large Plain Panel (No.
3)
(or panel of your choice) to the already
standing chosen panel with 3x50mm screws
as shown in diagram. Repeat this command
as you add an additional panel of your choice.
Do not secure the building to the floor until
the roof has been fitted,
Position the panels so there is equal spacing
between the floor and cladding on all sides.
9x50mm Screws
50mm
screw Pre drill
hole
2
3
3
Step 8
Parts needed - No. 3, (or 1, or 2 QTY 3)
Fix the end of the Large Plain Panel
(No. 3)
(or panel of your choice) to the already standing
chosen panel with 3x50mm screws as shown in
diagram. Repeat this command as you add an
additional panel of your choice.
Fix the corners of another Large Plain Panel
(No. 3)
(or panel of your choice) to either side
of the front of the building depending on
preference with 50mm screws as shown in the
diagram.
Do not secure the building to the floor until
the roof has been fitted,
Position the panels so there is equal spacing
between the floor and cladding on all
sides.
9 x50mm Screws
50mm
screw Pre drill
hole
3
3
3