Mercedes-Benz GLC Coupe 2016, Руководство пользователя

Страница: 341 / 377

Vehicles with 4MATIC may either be towed with
both axles on the ground or be loaded and trans-
ported.
!
Vehicles with automatic transmission must
not be towed with the rear axle raised. The
car/trailer combination may otherwise
swerve or even overturn.
!
The ignition must be switched off if you are
towing the vehicle with the rear axle raised.
Intervention by ESP
®
could otherwise dam-
age the brake system.
X
Switch on the hazard warning lamps
(
Y
page 116).
X
Move the front wheels to the straight-ahead
position.
X
If necessary, turn the key to position 0 in the
ignition lock and remove the key from the
ignition lock.
X
When leaving the vehicle, take the key with
you.
Towing the vehicle with all wheels on
the ground
Vehicles with automatic transmission: the
automatic transmission automatically shifts to
position P when you open the driver's or front-
passenger door or when you remove the key
from the ignition lock. In order to ensure that the
automatic transmission stays in position N
when the vehicle is being towed, you must
observe the following points:
X
Make sure that the vehicle is stationary.
X
Turn the key to position 2 in the ignition lock.
X
Depress the brake pedal and keep it
depressed.
X
Shift the automatic transmission to position
N.
Vehicles with manual transmission:
X
Turn the key to position 2 in the ignition lock.
X
Depress the brake pedal and keep it
depressed.
X
Depress the clutch pedal fully and shift to
neutral.
All vehicles:
X
Leave the key in position 2 in the ignition lock.
X
Release the brake pedal.
X
Release the electric parking brake.
X
Switch on the hazard warning lamps
(
Y
page 116).
In order to signal a change of direction when
towing the vehicle with the hazard warning
lamps switched on, use the combination switch
as usual. In this case, only the turn signals for
the desired direction flash. When you reset the
combination switch, the hazard warning lamps
start flashing again.
Transporting the vehicle
4MATIC vehicles/vehicles with auto-
matic transmission
!
When the vehicle is loaded for transport, the
front and rear axles must be stationary and on
the same transportation vehicle. Positioning
over the connection point of the transport
vehicle is not permitted. The drive train may
otherwise be damaged.
All vehicles
!
You may only secure the vehicle by the
wheels, not by parts of the vehicle such as
axle or steering components. Otherwise, the
vehicle could be damaged.
The towing eye or trailer tow hitch can be used
to pull the vehicle onto a trailer or transporter if
you wish to transport it.
X
Vehicles with manual transmission:
depress the clutch pedal fully and engage
neutral.
X
Vehicles with automatic transmission:
turn the key to position 2 in the ignition lock.
X
Shift the automatic transmission to position
N.
338
Towing away and tow-starting
Breakdown
assistance