Mercedes-Benz E-Class Wagon, Руководство оператора, Страница: 393 / 510

Aluminum hub cap
#
To remove: position socket 2 on hub cap
1 .
% The socket can be found in the tire-change
tool kit.
#
Position wheel spanner 3 on socket 2 .
#
Using wheel spanner 3 , turn hub cap 1
counter-clockwise and remove it.
#
To install: position hub cap 1 and turn until
it is completely flush with the wheel.
#
Position socket 2 on hub cap 1 .
#
Attach wheel spanner 3 to socket 2 and
tighten the hub cap clockwise.
Specified tightening torque: 18 lb-ft
(25 Nm).
#
Raise the vehicle (
→
page 391).
Raising the vehicle when changing a wheel
Requirements:
R
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
change (
→
page 390).
R
The hub caps have been removed
(
→
page 390).
Important notes on using the jack:
R
only use the vehicle-specific jack that has
been tested and approved by Mercedes-Benz
to raise the vehicle.
R
the jack is only designed for raising and hold‐
ing the vehicle for a short time while a wheel
is being changed and not for maintenance
work under the vehicle.
R
the jack must be placed on a firm, flat and
non-slip surface. If necessary, use a large,
load-bearing, non-slip underlay.
R
the foot of the jack must be positioned verti‐
cally under the jack support point.
Rules of conduct when the vehicle is raised:
R
Never place your hands or feet under the
vehicle.
R
Do not lie under the vehicle.
R
Do not start the engine and do not release
the electric parking brake.
R
Do not open or close any doors or the tail‐
gate.
Wheels and tires 391