radios) that may be being operated in or near the
vehicle.
Checking the tyre pressure electroni-
cally
X
Make sure that the key is in position 2 in the
ignition lock (
Y
page 145).
X
Press
ò
on the steering wheel to call up
the menu list.
X
Press
9
or
:
on the steering wheel to
select the
Service
Service
menu.
X
Confirm by pressing
a
on the steering
wheel.
X
Select
Tyre pressure
Tyre pressure
with
9
or
:
.
X
Press
a
to confirm.
The multifunction display shows the current
tyre pressure of each wheel.
If the vehicle was parked for longer than
20 minutes, the following message appears:
Tyre pressures will be displayed
Tyre pressures will be displayed
after a few minutes of driving
after a few minutes of driving
.
After a teach-in period, the tyre pressure moni-
tor automatically detects new wheels or new
sensors. As long as a clear allocation of the tyre
pressure values to the individual wheels is not
possible, the
Tyre
Tyre pressure
pressure monitor
monitor active
active
message is shown instead of the tyre pressure
display. The tyre pressures are already being
monitored.
If an emergency spare wheel is fitted, for a few
minutes the system may continue to show the
tyre pressure of the wheel that has been
removed. If this occurs, note that the value dis-
played for the position where the spare wheel is
fitted is not the same as the current tyre pres-
sure of the emergency spare wheel.
Warning messages of the tyre pressure
monitor
If the tyre pressure monitor detects a pressure
loss in one or more tyres, a warning message is
shown in the multifunction display. The yellow
tyre pressure warning lamp then lights up.
R
If the
Please correct tyre pressure
Please correct tyre pressure
message appears in the multifunction display,
the tyre pressure in at least one tyre is too
low. The tyre pressure must be corrected
when the opportunity arises.
R
If the
Check
Check tyre(s)
tyre(s)
message appears in the
multifunction display, the tyre pressure in at
least one tyre has dropped significantly. The
tyres must be checked.
R
If the
Warning tyre defect
Warning tyre defect
message
appears in the multifunction display, the tyre
pressure in at least one tyre has dropped sud-
denly. The tyres must be checked.
Observe the instructions and safety notes in the
display messages in the "Tyres" section
(
Y
page 277).
If the wheel positions on the vehicle are inter-
changed, the tyre pressures may be displayed
for the wrong positions for a short time. After a
few minutes of driving, this is rectified and the
tyre pressures are displayed for the correct
positions.
Restarting the tyre pressure monitor
When you restart the tyre pressure monitor, all
existing warning messages are deleted and the
warning lamps go out. The monitor uses the cur-
rently set tyre pressures as the reference values
for monitoring. In most cases, the tyre pressure
monitor will automatically detect the new refer-
ence values after you have changed the tyre
pressure. However, you can also set reference
values manually as described here. The tyre
pressure monitor then monitors the new tyre
pressure values.
X
Use the table on the inside of the fuel filler flap
to ensure that the tyre pressure is set cor-
rectly in all four tyres for the current operating
conditions.
Also observe the notes in the section on tyre
pressures (
Y
page 356).
X
Make sure that the key is in position 2 in the
ignition lock (
Y
page 145).
X
Press
ò
on the steering wheel to call up
the menu list.
X
Press
9
or
:
on the steering wheel to
select the
Service
Service
menu.
X
Confirm by pressing
a
on the steering
wheel.
X
Select
Tyre pressure
Tyre pressure
with
9
or
:
.
X
Press
a
to confirm.
The multifunction display shows the current
tyre pressure of each wheel or the
Tyre
Tyre
360
Tyre pressure
Wheels
and
tyres
