Mercedes-Benz 2010 E 350 4MATIC, Руководство оператора

Страница: 107 / 372

! If you have set intermittent wiping, dirt on
the surface of the rain sensor or optical
effects may cause the windshield wipers to
wipe in an undesired fashion. This could
then damage the windshield wiper blades
or scratch the windshield. You should
therefore switch off the windshield wipers
when weather conditions are dry.
X
Turn the combination switch to position
Ä
or
Å
.
After the initial wipe, pauses between
wipes are controlled by the rain sensor
automatically.
Intermittent wiping is interrupted when the
vehicle is at a standstill and a front door is
opened. This protects persons getting into or
out of the vehicle from being sprayed.
Intermittent wiping will be continued when all
doors are closed and
R
the automatic transmission is in drive
position
D or reverse gear R
or
R
the wiper setting is changed using the
combination switch
Single wipe
X
Press the combination switch briefly in
direction of arrow
B
to the resistance
point.
The windshield wipers wipe one time
without washer fluid.
Wiping with washer fluid
X
Press the combination switch in direction
of arrow
B
past the resistance point.
The windshield wipers operate with washer
fluid.
i To prevent smears on the windshield or
noisy/chattering wiper blades, wipe with
washer fluid every now and then even when
it is raining.
For information on filling up the washer
reservoir, see “Washer system and headlamp
cleaning system” (
Y
page 227).
For information on cleaning the headlamps
with washer fluid, see “Headlamp cleaning
system” (
Y
page 102).
Problems with wipers
!
If anything blocks the windshield wipers
(leaves, snow, etc.), switch them off
immediately.
For safety reasons, do the following before
attempting to remove any blockage:
R
Stop the vehicle in a safe location.
R
Remove the SmartKey from the starter
switch.
or
R
Turn off the engine by pressing the
KEYLESS-GO start/stop button and
open the driver’s door (with the driver’s
door open, starter switch is in position
0, same as with SmartKey removed from
starter switch).
R
Engage the parking brake.
R
Remove blockage.
R
Turn the windshield wipers on again.
If the windshield wipers fail to function at
all with the combination switch in position
Ä
or
Å
,
R
set the combination switch to the next
higher wiper speed
R
have the windshield wipers checked at
the nearest authorized Mercedes-Benz
Center
Power windows
Opening and closing
The door windows are opened and closed
electrically. The switches for all door windows
are located on the driver’s door control panel.
Power windows
105
Controls in detail
212_AKB; 2; 41, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-17T09:14:21+02:00 - Seite 105
Z