Mercedes-Benz 2010 E 350 4MATIC, Руководство оператора

Страница: 327 / 372

X
On the wheel to be changed, loosen but do
not yet remove the wheel bolts
(approximately one full turn with wheel
wrench
:
).
The jack take-up brackets are located directly
behind the front wheel housings and in front
of the rear wheel housings.
E 63 AMG and vehicles with AMG
bodystyling: The respective cover in the
door-sill trim must be removed to access the
jack take-up brackets.
Example illustration: Vehicles with AMG
bodystyling
X
E 63 AMG and vehicles with AMG
bodystyling: Remove cover
;
in direction
of arrow.
G
Warning!
The jack is designed exclusively for jacking up
the vehicle at the jack take-up brackets. Make
sure the jack arm is fully seated in the jack
take-up bracket.
If you do not position the jack correctly in the
jack take-up bracket, the vehicle can fall off
the jack and seriously or fatally injure you or
others.
! Do not position the jack on the body of
the vehicle, as this may cause damage to
the vehicle.
X
Place jack
?
on firm ground.
X
Position jack
?
under take-up bracket
=
so that it is always vertical as seen from
the side, even if the vehicle is parked on an
incline.
X
Turn crank
A
clockwise until jack
?
is
fully seated in take-up bracket
=
and the
jack base evenly meets the ground.
X
Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the ground.
Flat tire
325
Practical hints
212_AKB; 2; 41, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-17T09:14:21+02:00 - Seite 325
Z