Corrections
5
Remove rocker arm bearing support
(05235).
6
Press hydraulic valve clearance compens-
ating element
together with the washer
carefully out of the rocker arm with an
aluminum or brass mandrel, and finally slide into
the rocker arm up to the snap ring stop (56)
again. Use a thinner washer (residual stroke too
small) or a thicker washer (residual stroke too
large).
If specified residual stroke cannot be achieved
with the washers available
depending on
residual stroke measured, use a thinner or
thicker ball socket (55) (see note, on the washer
and ball socket tables).
Caution!
Before carrying out the installation fill reservoir
chamber of the hydraulic valve clearance com-
pensating element with engine oil
211,
Number 3).
The grooves in the washer (57) must point in the
direction of the compensating element
7
Install rocker arm bearing support (05-235).
8
Repeat tests, Numbers 1 to 3.
Note
Before carrying out the test turn the crankshaft a
few times by using the starter.
9
The installation is carried out in the reverse
sequence of the removal.
10 Check for leaks when engine is running.
05.0906
Содержание 201.024
