Inserting the brackets into the loading
rail
X
Insert bracket
:
into the centre of loading
rail
?
.
X
Press release button
;
and push
bracket
:
into the desired position in load-
ing rail
?
.
X
Let go of release button
;
.
X
Press locking button
=
.
Bracket
:
is locked in loading rail
?
.
X
If necessary, fold lashing eyelet
A
upwards.
G
Risk of injury
Distribute the load on the lashing eyelets
evenly.
Otherwise, vehicle occupants could be
injured by objects being thrown around if you:
R
brake sharply
R
change direction suddenly
R
are involved in an accident
Please observe the loading guidelines.
Luggage holder
The luggage holder can be used to secure
light loads against the side wall of the luggage
compartment to prevent them from moving
around.
X
To install: insert two brackets
A
into the
left or right loading rail (
Y
page 203).
X
Press release button
:
of the luggage
holder and pull the belt out slightly.
X
Insert luggage holder
;
into brackets
A
and, while doing so, press release button
=
and push the luggage holder downwards
until it engages.
X
Press release button
:
of the luggage
holder and pull the belt out slightly in the
direction of the arrow.
X
Place the load between the belt and the
luggage compartment side wall.
X
Using one hand, press locking button
:
of
the luggage holder.
X
With your other hand, slowly extend the
belt around the load until it is secure.
X
Make sure that locking button
?
on brack-
ets
A
is pressed.
This keeps brackets
A
in place on the
loading rail.
X
To remove: press release button
=
on
respective bracket
A
and remove luggage
holder
;
by pulling upwards and out.
Telescopic rod
The telescopic rod can be used to secure the
load against the rear seats to prevent it from
moving around.
Loading and stowing
203
Cont
ro
ls
212_AKB; 2; 4, en-GB
mkalafa,
Version: 2.11.8.1
2009-05-05T14:17:16+02:00 - Seite 203
Z
Dateiname: 6515346702_buchblock.pdf; erzeugt am 07. May 2009 14:16:46; WK
