Mercedes-Benz 2007 CL 550, Руководство оператора

Страница: 186 / 723

185
Control systems
COMAND navigation system (entering a destination)
Moving the map and selecting the des-
tination
왘
Moving map: Slide
q m r
,
o m p
or
w m x
.
왘
Adjusting map scale: Rotate
y m z
.
Rotating clockwise enlarges the map,
rotating counterclockwise reduces it.
왘
Selecting a destination: Press
n
.
If the crosshair is located off the edge
of the digital map, a route cannot be
calculated to this destination and you
will see the message “
The destination is
located off the map. ”.
왘
Select “ OK ”.
왘
Move the map and select a destination
again.
If the destination is within the limits of
the digital map, COMAND attempts to
attribute the destination to the map,
which can take approximately
2 seconds.
If the destination can be attributed, you
will see the address of the destination.
If not, you will see the display “
Destina-
tion from map ”.
왘
Starting route calculation:
Select “ Start ”, see also (
컄
page 181).
Entering a stopover
i
When route guidance is active, you can en-
ter a stopover. Stopovers can be predefined des-
tinations from the following predefined
categories:
앫
“Mercedes-Benz Center”
앫
“Hospital”
앫
“Gas station”
앫
“Parking lot”
앫
“Restaurant”
However, you can also enter destinations other
than the predefined ones.
i
You can use the stopover function to influ-
ence the route guidance calculation to the main
destination. When you have reached your stop-
over, COMAND automatically calculates the
route to the main destination.