MetroX 12-Port QSFP InfiniBand Long Haul System Hardware User Manual
Rev 1.1
Mellanox Technologies
43
Figure 29: Air Flow Labels
To extract a Fan Unit
1. Using two fingers, push both latch releases towards each other simultaneously while pulling
the fan module out of the switch. As the fan unseats, the fan status indicator will turn off.
2. Remove the fan unit.
Figure 30: Fan Module Latches
To insert a FAN Unit:
1. Make sure the mating connector of the new unit is free of any dirt and/or obstacles.
2. Insert the fan unit by sliding it into the opening until slight resistance is felt. Continue press-
ing the fan unit until it seats completely.
The green fan status indicator should light. If not, extract the fan unit and reinsert it.
After two unsuccessful attempts to install the fan unit, power off the switch before
attempting any system debug.
OK
!
!
OK
OK
!
These air flow labels must be the same
These two latches must be pushed towards each other at the
same time while the module is pulled out.
Push Here
Push Here
