MetroX 12-Port QSFP InfiniBand Long Haul System Hardware User Manual
Rev 1.1
Mellanox Technologies
33
power cords should be standard 3-wire AC power cords including a safety ground and rated for
15A or higher.
Figure 24: Two Power Inlets - Electric Caution Notifications
3.6
Configuring the Switch the First Time
The procedures described in this chapter assume that you have already installed and powered-on
your switch according to the instructions in this document.
Step 1.
Connect the host PC to the Console (RJ-45) port of the switch system using the supplied cable.
The Console ports for systems are shown below as examples.
Caution: The switch platform will automatically power on when AC power is applied.
There is no power switch. Check all boards, power supplies, and fan tray modules for
proper insertion before plugging in a power cable.
Caution: After inserting a power cable and confirming the green system status LED
light is on; make sure that the Fan Status indicator shows green.
If the fan status indicator is not green then unplug the power connection and check that
the fan module is inserted properly and that the mating connector of the fan unit is free
of any dirt and/or obstacles.
Caution: When turning off the switch, make sure ALL Connector LEDS are off to
ensure a powered down status.
Do not hot swap the power supply if your switch has only one power supply. You must
power down the system to replace the power supply unit when there is only one PS
unit in the switch.
CAUTION
Risk of electric shock and energy
hazard. The two PS units are
independent.
Disconnect all power supplies to
ensure a powered down state
inside of the switch platform.
ACHTUNG
Gafahr des elektrischen
Schocks. Entferrnen des
Netzsteckers elnes Netz-
teils spannungsfrei. Um
alle Einhieten spannungs-
frei zu machen sind die
Netzstecker aller Netzteile
zu entfernen
ATTENTION
Risque de choc et de danger
e’lectriques. Le de’branch-
ment d’une seule alimentation
stabilise’e ne de’branch
uniquement qu’un module
“Alimentation Stabilise’e”.
Pour isoler completement le
module en cause, Il faut
de’brancher toutes les alimen-
tations stabilise’es.
