6 Setup Menu
The front panel of the ANZ14 contains two push buttons
(A+B)
. Pressing both buttons at the same time for at
least one seconds enable the Setup Menu. This menu allows the configuraion of all the features provided by
the ANZ14.
ANZ14
Menu
Set
All available sub menus are selected by the upper push button
A
while the lower push button
B
is used to set
the value or to select the available options.
6.1 Enter [En.]
The first menu is the entrance into the setup menu. Button
B
is pressed to exit the setup menu without any
change. Button
A
is used to jump to the next sub menu. The available sub menus are described in the following.
The changes will not become valid until the configuration is saved in the last sub menu of the setup menu.
6.2 Brightness [Br.]
The brightness of the display can be set in steps from 0 to 9, where 0 represents the most dimmed brightness
and 9 the maximum brightness. The value is selected by using the button
B
. Pressing
A
enters the next sub
menu.
6.3 Time Zone [TZ]
The time zone of the LED display can be set here. With pressing the button
B
the possible selectable zones are
displayed in the following sequence: CET (Central European Time or CET), EET (East European Time) or UTC
(without summer time). This setting is only relevant when the ANZ14 is DCF77-synchronized. If synchronization
is done by serial interface or by an NTP time server, the received time is displayed always (LOCAL). With
pressing the button
A
you will switch to the next submenu.
26
Date: 28th October 2019
ANZ14/ANZ14DCF/ANZ14NET
Содержание ANZ14
Страница 2: ......
