Meilhaus Electronic ME-5004, Руководство пользователя

Страница: 11 / 39

2.3 Fitting the Plug-on Boards
The boards should be handled with care in order to make sure that
the device is not damaged by electrostatic discharge (ESD), me-
chanical stress or unsuitable current surges. Precautions should
also be taken to avoid an electric shock. Ensure that standard ESD
safety precautions are taken. At least one hand should be
grounded in order to dissipate any static charge.
Observe the following procedure:
1. If the base board is installed, you must first remove it in or-
der to be able to insert the plug-on board. Here you should
observe the procedure as described in the manual for your
PC system.
2. Make sure that electrostatic discharges cannot take place
through the plug-on board or the base board as you plug it
in. Follow the standard ESD safety precautions.
3. Push the plug-on board carefully, and with only a little force,
on to the male connector provided for it (see Diagram 1 ,
items 1, 2 and 3). Check that the board is fully plugged in.
4. Choose two adjacent slots for the installation. If necessary,
remove an additional mounting bracket for the slot of the
plug-on board.
5. Carefully plug the combination of the base and plug-on board
into the computer.
6. Screw the two slot brackets down firmly.
7. Close the PC system again.