Meicheng IS-LT01, Инструкция по установке и эксплуатации

Страница: 16 / 28

Menu Operation
10
After powering up, the camera automatically gets into tracking mode. If tracking settings needs to
be made, the camera must be stopped from tracking.
The way to judge whether the camera is on tracking or non-tracking status is: if there is red
character shown, it is on non-tracking status.
In non-tracking mode, CALL preset 95 to enter / exit main menu. Press Iris OPEN button of your
controller to confirm, then gets into submenu.

CALL preset 95 to get into main menu
1. Set tracking parameters
：
has 4 submenus, set according to actual requirement.
2. Set valid area
：
h
as 6 submenus, set according to actual working environment.
3. Set projection screen area
：
has 4 sub-menus, set once projector is used in actual working
environment.
After settings are made from every further sub-menu, Set preset 96 to save current settings. If no
setting is made from every further sub-menu, Set preset 96 will exit the menu without saving
settings. If setting needs to be made again, Call preset 95 to get into menu again and Set
Tracking Setting
preset 96
to save settings again
Sub-menu 1.Set tracking parameters has below settings: Set Tracking Speed, Set Tracking
Sensitivity, Auto Zoom (on/off) and Auto Tilt Motion (on/off).
=> 1. Set tracking parameters
=> 2. Set valid area
=> 3. Set projection screen area