Troubleshooting Check List
(continued)
Confirming wiring and connections for all devices:
_____ Machine VMC
MDB cable connects to the bill validator and…
_____ The bill validator cable connects to the ADV 5XXX
cable and…
_____ The ADV 5XXX cable connects to the Coin Changer.
_____ If machine has i-Vend, i-Vend should follow the ADV 5XXX on the
MDB bus.
_____ Ensure the SIM Card (if used) is fully inserted into the slot.
Confirming Fill Key Success:
_____ Confirm that ADV 5XXX red
LED’s have returned to the “Ready
and On-
Line indication”
ADV 5XXX Compliance
–
The ADV 5XXX series Modular Data Port uses radio energy
to communicate vending transaction activities to a remote host.
MEI has not approved any changes or modifications to the ADV 5XXX.
Any changes or modifications could void the user’s authority to
operate the equipment. See 47 CFR Sec. 15.21
The ADV 5XXX series complies with 47 CFR Sec. 15.19(3)
of the FCC Rules and Industry Canada RSS-GEN 7.1.5. Operation
is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesirable operation.
May Contain FCC ID: May Contain transmitter module IC:
N7NWISMO228 2417C-WISMO228
N7NSL5011 2417C-SL5011
N7NSL8080 2417C-SL8080
To be sure that human exposure to RF energy does not exceed
the guidelines in the relevant standards, always follow these
instructions:
A minimum of 20cm (8 inches) should be maintained between
the antenna and all persons and must not be co-located or operated
ADV 5XXX Compliance
–
(continued)
in in conjunction with any other antenna or transmitter. Only the antenna
s supplied with this device is to be used or the user may void the
a authority to use this device.
DO NOT
hold the antenna when the ADV 5XXX is in use. Holding the
antenna will affect call quality and may cause the radio to operate at a
higher power level than needed.
Guidance - Pacemakers, Potential Interference -
Radiofrequency energy (RF) from cell phones can interact with
some electronic devices. This type of interference is called
electromagnetic interference (EMI). For this reason, FDA helped
develop a detailed test method to measure EMI of implanted cardiac
pacemakers and defibrillators from cell phones. This test method is now
part of a standard sponsored by the Association for the Advancement of
Medical Instrumentation (AAMI). This standard will allow manufacturers
to ensure that cardiac pacemakers and defibrillators are safe from cell
phone EMI.
The FDA continues to monitor the use of cell phones for possible
interactions with other medical devices. Should harmful interference be
found to occur, FDA will conduct testing to assess the interference and
work to resolve the problem.
For more information reference sources for pacemakers can be found at
U.S. Food and Drug Administration web site:
Radiation-Emitting Products and procedures, Interference with
Pacemakers and Other Medical Devices.
16
17
