Installation Instructions
1) Check vending machine for normal operation and clear all errors.
2) Power
OFF
the vending machine door.
3) Connect the Power/ MDB harness and the DEX harnesses to the
ADV 5XXX. Observe the orientation of the key on each plug.
4) Connect the GPRS antenna cable.
Note: The GPRS antenna is identified by a screw type
connector that attaches to the GPRS radio.
FINGER TIGHTEN
ONLY
.
5) Select a location for the ADV 5XXX in the vending machine
and “dry test” the fit. Check for visible machine obstructions,
harness routing options, and harness length requirements.
Note: It is strongly recommended that the GPRS antenna be mounted
on a horizontal plane outside the vending machine. This may be
accomplished by drilling a 1/2” hole through the top of the vending
machine and threading the antenna cable inside. The GPRS antenna
strength may be influenced by digital signal in the area and placement
constraints in or on the vending machine.
6) Once satisfied with the potential ADV 5XXX location, remove
the ADV 5XXX with attached harnesses and set aside.
Thoroughly clean the machine surface around the areas
where the ADV 5XXX and where the Antenna will be installed.
The surface should be clear of any dirt, dust, oils, or other
foreign substances.
7) Disconnect the Antenna, Power /MDB, and the DEX cables from
the ADV 5XXX and set aside.
8) Remove the plastic adhesive backing from the hook and loop
strips on the back of the ADV 5XXX and firmly secure the
ADV 5XXX to the chosen mounting location. Attach the
wiring harnesses and check the security of the cable
connections once the ADV 5XXX has been secured to the
machine surface.
9) Install wire tie anchors below the ADV 5XXX cable connections.
Using the wire ties provided, secure the cable
harnesses to the
anchors.
10) The MDB power and communication route should be as
follows:
a. From the VMC to the ADV 5XXX Power MDB harness
b. From the harness to the ADV 5XXX and to the bill validator
MDB harness
c. From the bill validator MDB harness to the Coin Mechanism
harness.
11) Install GPRS Antenna. The GPRS antenna is identified by a
screw type connector that attaches to the GPRS radio. It is
strongly recommended that this antenna be mounted on a
horizontal plane (the top) outside the vending machine. This
may be
accomplished by drilling a 1/2” hole through the top of
the vending machine and threading the antenna cable inside.
An extension adapter is available for Dixie Narco 5000
machines. Thoroughly clean the machine surface around the
area where the GPRS antenna will be installed. The surface
should be free of any dirt, dust, oils, or other foreign
substances.
Warning
:
The antenna must be connected to the
Easitrax
TM
ADV 5XXX
prior
to power up. Powering up the
Easitrax
TM
ADV 5XXX before connecting the antenna may
damage the unit.
Notice:
“Changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.”
6
7
