M
AVTM246004 BITE 2/2P Rev 4 July 2011
46
2.
Press
on the
receiver
to choose POWER DOWN.
The
receiver
prompts you to confirm your decision.
Y
ARE YOU SURE?
N
(Y/N)?
MENU
3.
Press
on the
receiver
to enter Y (YES). The
receiver
powers down.
4.
Disconnect the
CT
from the battery and the
receiver
.
You can now power down the
transmitter
.
5.
To power down the
BITE 2/2P
transmitter
, press the
Current ON/OFF switch to disconnect the current
source. Then press the
transmitter
power switch to the
O
(OFF) position.
F
WARNING
Do not remove the BITE 2/2P transmitter current source
leads from the battery until the BITE 2/2P transmitter is
powered down. Always disconnect the current source
leads from the battery before removing them from the J2
connector on the transmitter.
6.
Remove the
current source leads
from the battery.
7.
Remove the
current source leads
from the J2 connector
on the
transmitter
.
Remember to recharge the
receiver battery. Refer to
"Charging the Receiver" on page
74 for detailed procedures.
8.
Unplug the power cable and then disconnect it from the
J1 receptacle on the
transmitter
.
G
CAUTION
Do not leave the BITE 2/2P connected to the battery when
not in use.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
