STANDARD TEST PROCEDURE
AVTM246004 BITE 2/2P Rev 4 July 2011
33
Step Five: Splitting the Strap (if needed)
After the Wand Menu and Enter Baseline menu, the
receiver
displays a screen that asks whether you want to split the
strap.
You need to split the strap if the strap you want to measure
consists of more cables or intercell connectors than the
diameter of the clamp-on current sensor (CT) can handle.
Y
SPLIT STRAP
N
(Y/N)? MENU
NOTE:
Splitting a strap may not split the current equally. Verify
that the current is split fairly evenly between the straps. If the
current split is not even, then try to find another location where
the current is more evenly split.
If You Do Not Want
to Split the Strap
If you do not want to split the strap, simply press
(for NO)
on the
receiver
, which instructs the
receiver
not to split the
strap.
You are prompted to connect the
CT
to the strap. Proceed to
“Step Six: Connecting the Receiver and the BITE 2 or BITE 2P
Transmitter to the Battery” on page 35.
If You Want to Split
the Strap
If you want to split the strap:
1.
Press
on the
receiver
to enter Y (for YES).
The
receiver
prompts you to enter a multiplier, which is a
numeric value that the
receiver
uses to determine the
measurement of the entire strap.
UP
MULTIPLIER
DN
>1_<
ACCEPT
www.
GlobalTestSupply
.com
Find Quality Products Online at:
