Megamaster 200 Fusion, Инструкции по сборке и эксплуатации

Страница: 32 / 36

GREASE TRAY CLEANING
The grease tray should be emptied and wiped down periodically and washed with a mild detergent
and warm water solution. A small amount of sand may be placed in bottom of grease tray to absorb the
grease. Check the grease tray frequently, do not allow excess grease to accumulate and overflow out
of the grease tray.
This unit must be kept in an area free from combustible materials, gasoline and other flammable
vapors and liquids.
Make sure all openings into the grill body are free of blockages or debris and there are no objects or
materials blocking the flow of combustion or ventilation. Make sure the legs are in the up position
when using the grill.
Check burner air inlet openings (behind the inlet guard on the right end of the grill body) for insect
nests or blockages. Make sure the slots in the burner tube are clear.
When the grill is not in use, turn the control knob to the “OFF” position and remove the LP Gas cylinder
from the regulator. Remove the regulator from the burner.
FOR OUTDOOR USE ONLY
This cooking appliance is for outdoor use only and should not be used in a building, garage or any
other enclosed area. If stored indoors, detach LP Gas cylinder and store outdoors. LP Gas cylinders
must be stored out of reach of children.
FIRST-TIME USE
It is important that the grill be lit and allowed to heat up for at least 30 minutes before any food is
placed on the cooking grid. It is normal for some smoke to appear during the initial operation of the
grill. After initial heating, the grill is ready for use. A cooking spray can be used on the cooking grids to
allow easier clean up.
WARNING:
If you wish to replace main burner, we strongly recommend that you hire a professionally trained
technician to replace it. Please understand that we will not be responsible for any liability, personal
injury, or property damage resulting from an improperly assembled burner.
MOVING INSTRUCTIONS
Caution: Never move the grill with burner lit.
Make sure control knob is in the “OFF” position. Disconnect the LP Gas cylinder from the regulator.
Remove the regulator from the grill. Be sure the grill has completely cooled for at least 30 minutes.
Close the lid and secure the latch. Place the legs in the down position. Use the handle to carry the grill.
Note: It is best to leave the grease tray in place attached to the bottom of the grill; some grease may
continue to drip from drain hole during transport.
31
CARE & MAINTENANCE