Megamaster 200 Fusion, Инструкции по сборке и эксплуатации

Страница: 10 / 36

THE FUEL SYSTEM
Gas grills are used safely by millions of people when following simple safety precautions.
The items in the fuel system are designed for operation with this grill. They must not be replaced with any
other brand. (See parts list for replacement items.)
GAS BURNER
The gas burner is constructed of stainless steel and should not require maintenance other than inspection
for insects/nests inside the air intake slots.
LP GAS REGULATOR CAUTION
The gas pressure regulator provided with this appliance must be used. This regulator is equipped with the
required orifice and is set for the required outlet pressure for this appliance. This combination of orifice size
and pressure regulation specifications provides the cooking performance intended by this Megamaster
Table Top Grill. Substitution of regulator by any other device or any other manufacturer is dangerous and
could result in serious injury. The correct type of regulator to be used is 2,8kPA low pressure regulator.
FUEL SUPPLY HOSE
The hose connected regulator provided with this appliance is 3 feet (91.4cm) length. Keep the fuel hose
away from any heated surface(s).
LP GAS FUEL
Warning – LP Gas is a flammable gas. Improper handling may result in an explosion and/or fire and serious
accident or injury. Your grill is designed to operate with LP Gas only and is equipped with the proper orifice
for LP Gas gas.
CAUTION:
Do not connect this grill with any gas supply other than LP Gas. LP Gas is heavier than air and
settles in lower areas. Make certain adequate ventilation is available when using your grill. The gas cylinder
may be stored outside in a well-ventilated area out of the reach of children when the grill is not in use.
The LP gas cylinder shall be used only outdoors in a well-ventilated space and not in a building, garage, or
any other enclosed area. The Megamaster Table Top Grill may be stored indoors if the LP gas cylinder is
removed and stored outdoors. The LP gas cylinder (not included) is threaded for connection directly to the
gas regulator supplied with this appliance. Care should be taken when threading the cylinder to the
regulator to engage threads correctly to achieve the proper and intended connection. When disconnecting
or connecting the gas cylinder, be careful that the regulator does not strike the grill, the ground, or any
other surfaces. Replace the protective cap over the threaded cylinder connection when removed from grill.
If any difficulty occurs when connecting or disconnecting the cylinder to the regulator assembly, contact
your local gas supplier for assistance.
When reconnecting the LP gas cylinder to the regulator, be sure to hand-tighten until snug. This connection
should be inspected for damage and leak tested after each reconnection.
TO DO A LEAK TEST : make a soap solution of one part liquid detergent and one part water. You will need
a spray bottle, brush, or rag to apply the solution to the fitting. Bubbles indicate leaks.
Check all gas supply fittings for leaks before each use. Do not use the grill until all connections have been
checked and do not leak.
10
SAFETY FIRST, LAST & EVERYWHERE IN BETWEEN
REGULATOR
LPG GAS CYLINDER