Megamaster 200 Fusion, Инструкции по сборке и эксплуатации

Страница: 6 / 36

CAUTION: BEWARE OF BURN-BACK
Spiders and small insects occasionally spin webs or make nest in the grill burner tubes during
transit and warehousing. These webs can lead to gas flow obstruction, which could result in a fire in
and around burner tubes. This type of fire is known as
“BURN-BACK” and can cause serious
damage to your grill and create an unsafe operating condition for the user.
Although an obstructed burner tube is not the only cause of “BURN-BACK” , it is the most common
cause.
In the event of “BURN-BACK” , where the flame burns back to the jet, immediately turn off the gas
supply at the burner control valve.
After ensuring that the flame is extinguished, re-light the appliance as described in below. Should
the appliance again
“BURN-BACK” , close the valves and examine the mixing tube or burner for any
obstruction. If there are no obstructions and the burn back still occurs, call a technician to examine
the appliance and make any necessary repairs.
Do not make any unnecessary adjustments or modifications to this grill, a qualified LP gas
technician should do any adjustments.
To reduce the chance of “BURN-BACK” , you must clean the burner tubes before assembling your
grill, and at least once a month in late summer or early fall when spiders are most active.
Also perform this burner tube cleaning procedure if your grill has not been used for an extended
period of time. A clogged tube can be lead to a fire beneath the grill.
Visually check the burner flames prior to each use; the flames should appear 1 inch tall (+/-).
If they do not,
refer to the burner main tenancy part of this manual.
WARNING
Keep any electrical supply cord and the fuel supply hose away from any heated surfaces
PLEASE NOTE
The normal flow of gas through the regulator and hose assembly can create a humming noise.
A low volume of noise is perfectly normal and will not interfere with operation of the grill.
If humming noise is loud and excessive you may need to purge air from the gas line or reset the
regulator excess gas flow device. This purging procedure should be done every time a new LP gas
cylinder is connected to your grill.
6
SAFETY FIRST, LAST & EVERYWHERE IN BETWEEN