Media5 Mediatrix 4116, Руководство по установке оборудования

Страница: 20 / 60

Chapter 2 - Installation Hardware Installation
10 Mediatrix 4100 – Analog Access Device
Cleaning
To clean the Mediatrix 4100, wipe with a soft dry cloth. Do not use volatile liquids such as benzine and thinner
that are harmful to the unit casing.
For resistant markings, wet a cloth with a mild detergent, wring well and then wipe off. Use a dry cloth to dry
the surface.
Hardware Installation
This section describes how to set the connectors of the Mediatrix 4100.
See “Appendix B - Cabling Considerations” on page 29 for more details on the cables the Mediatrix 4100 uses.
Connecting Cables – Mediatrix 4108/4116 Models
The following describes how to connect the various cables to the Mediatrix 4108 or Mediatrix 4116.
Figure 6: Mediatrix 4108/4116 Hardware Installation

To install the cables:
1. Before you begin, be sure that the Mediatrix 4100 is powered off.
2. Connect the power cord to its connector on the rear of the unit. Do not yet connect the other end of
the power cord to an electrical outlet.
3. Connect analog telephones or fax machines into the phone/fax connectors
The Mediatrix 4108 has 8 connectors, while the Mediatrix 4116 has 16 connectors.
Use a standard telecommunication cord with a minimum of 26 AWG wire size.
Warning:
Do not connect the Mediatrix 4100 directly to Telecommunication Systems.
Caution:
The Mediatrix 4100 must be installed on a circuit equipped with a breaker so that you can easily
power the unit off if required.
3
5
4
3
3
4
5
Note:
The Mediatrix 4100 telephone line interface has been designed to interface with a conventional
telephone or fax machine. Connections to FXS ports of third party devices such as a PBX / Key System
could damage the Mediatrix 4100.