9
MACHINE PREPARATION
4.
SQUEEGEE ASSEMBLY
The squeegee, which is packed separately from the machine, should be
assembled as shown in the figure. Insert first the left squeegee pin (1) in the
left arm slot, then the right pin (2) into the right slot, paying attention to keep
the spring and the washer over the blade of the arm itself. To simplify this
operation the handwheel placed on top of the pin should be loosened
previously. Afterwards, lock the handwheel to block the squeegee in position.
Fit the squeegee hose into its coupling (3)
2
3
1
5. ADJUSTMENT SQUEEGEE HEIGHT
The squeegee has to be regulated in height depending on the wearing of the
rubbers. To adjust this, rotate the knob (1) of each wheel clockwise to lift the
squeegee and counterclockwise to lower it.
Note:
The right and left wheels must be adjusted at the same amount so that
the squeegee works in parallel to the floor.
6. ADJUSTMENT SQUEEGEE INCLINATION
During working operation, the rear rubber has to work slightly tilted backwards
and this equally in its whole length for about 5mm. Should it be necessary to
increase the rubber bending in the central part, tilt the squeegee body
backwards and turn the adjuster (1) counterclockwise. If the rubber bending is
to be noticeable at the sides of the squeegee, turn the adjuster clockwise. At
the end of the adjustment, block the adjuster nut.
