MED Automotive MED 6000.LW, Руководство пользователя

Страница: 12 / 20

WIRELESS SENSORS PROGRAMS
The wireless sensors supplied in the pack are already paired with their control unit
PAIRING WIRELESS SENSORS OF SERIES MIC LW, MIC MEC LW, SEN INFRA LW
30
LED / BUTTON SIR 050
12 + 5 times
MIC LW 2 seconds
3 times
MIC MEC LW 2 seconds
3 times
SEN INFRA LW SEN INFRA 360 LW
3 times
3 times
2 2
4 4
6 6 30
[+15] ON OFF
WARNING:
1 Beep OFF ON
2, 4 6 Beeps blinks 3
(12 TIMES)
The battery-holder supports can only be fitted in the MIC LW and MIC MEC
LW if they are already complete with the battery CR 2032, otherwise it will be
impossible to take them out again.
It adds new sensors.
It adds new sensors of series , as sensors
It activates the operational test for all the sensors of series:
It deletes all the paired sensors of series:
PAIRING WIRELESS SENSORS OF SERIES MIC LW, MIC MEC LW, SEN INFRA LW
5
FORCED PAIRING OF CHOKED WIRELESS SENSORS
7 MIC LW MIC MEC LW choked
TESTING WIRELESS SENSORS
12 MIC LW, MIC MEC LW, SEN INFRA LW
ELIMINATING WIRELESS SENSORS
20 MIC LW, MIC MEC LW, SEN INFRA LW
.
The procedure is used to manage the sensors of series MIC LW and MIC MEC LW, which are
always enabled when the system is activated, up to a maximum number of
, and the infrared
sensors SEN INFRA LW.
You are recommended to carry out the procedure on a workbench, or in any event near the
alarm control unit before fitting the sensors on the vehicle, making sure to install the power
supply batteries in them beforehand.
The
and the siren must be connected when the control unit is powered.
1) Once in programming mode (button of the LED pressed ) according to the
procedure just described, which is confirmed by the signals indicated, the LED is now lit
steady. You can now add new sensors in addition to those supplied in the pack (which do not
have to be paired again), as follows:
2) = Rest the magnet for and move it away from the arrow over the
MED mark, until confirmation is given consecutively.
= Press the built-in button of the sensor for and release it, until
confirmation is given consecutively.
/ - The infrared sensors are supplied in TEST mode,
therefore after pairing them and testing them on the vehicle, they have to
be set in standard service mode, following the instructions below.
Pass in front of the sensor until its LED switches on and the control unit
provides confirmation
consecutively, or simply open and close the
casing, again consecutively (the anti-sabotage button trips).
Control unit confirmation:
- Beeps close together and blinks of the LED confirm that the sensor has been stored.
- Beeps close together and blinks of the LED indicate that this sensor has already been
enabled.
- Beeps close together and blinks of the LED when all sensors envisaged have
already been enabled.
To add others, delete those already paired via the specific program and teach-in just those
really in use again.
3) End the procedure, switch the ignition key and once.
- Perform the teach-in procedure slowly and always make sure the confirmation signals are
given:
-
, LED and after each transmission;
- or and of the LED after the sequential transmissions for each sensor.
10