DIRECTION INDICATORS FLASHING ON THE SYSTEM ACTIVATION / DESACTIVATION
ACOUSTIC SIGNALINGS ON ACTIVATION / DESACTIVATION
OUT OF ORDER OF THE SYSTEM
BUTTONS INPUT DESACTIVATING
WARNING:
To use only in case one button or one additional sensor is broken waiting for their repair.
DOORS LOCKING / UNLOCKING TIME
STATUS OUTPUT - TIMED STATUS SIGNAL
1,25 secondi.
STAND-BY TIME OF THE INSTANTANEOUS / DELAYED BUTTONS INPUT
ALARM OUTPUT
NUMBER OF ALARM CYCLES FROM THE BUTTONS INPUTS
RESETTING OF THE INITIAL CONDITIONS PROGRAMMED AT DEFAULT
To activate signalling also when activating / deactivating, besides in the alarm state
The exclusion function just keeps the service indications enabled: alarm memory, input of
emergency code, input refusal, and programming.
Suggested in case the vehicle has to stay in the repair shop, garage, or when the vehicle does
not need to be protected. See PROGRAMMINGS. When OUT OF ORDER, the system cannot
be activated and any attempt gives 5 BEEPS and 5 LED flashings. It cuts out all the central unit
functions. It excludes all the functions of the control unit, including the PANIC function.
Repeat the programming to activate the system completely again.
It is used to disable the detection function of the door, bonnet and boot buttons, leaving the other
protection systems activated: starting, volumetric radar sensor, wireless sensors.
It may also disable supplementary modules, if connected to the Light Blue/White wire.
The standard preset times are
When the system is activated, the analogue input of the
may be
instantaneous or delayed by 30 or 50 seconds (for the initial seconds and then it becomes
instantaneous). It must be delayed when the signal is taken by the delayed switching off internal
roof lamp or if are used the additional modules (anti lifting, high frequency, infra red etc).
The set up depends on the vehicle model and on the paired accessories)
It has to be kept intermittent only if it's used to control the vehicle klaxon otherwise fix in case of
an additional siren.
It is used to execute 3 alarm cycles from the analogue buttons line (rather than just 1), if the
alarm condition persists (for example: opening and leaving a door open; if it is closed again
before the end of the 3 cycles, the alarm stops at the end of the current cycle).
The alarm cycles are repeated if the door is subsequently opened again.
It allows to restore the original condition of the central unit, resetting all the default
programmings.
.
Light Blue/White wire
With vehicles having a “comfort” equipment (simultaneous windows closing by turning the
original key in the door lock block), it is possible “to automate” the windows closing on the
system activation delaying the doors locking time or using the status output as timed, according
to the vehicle's features.
If necessary, it is possible to let the controls of the doors locking and of the windows closing be
simultaneous, and to preset the opening / closing times at 3 seconds (for example, vehicles
equipped with pneumatic system like MERCEDES W 124 - W 129 series).
With vehicles equipped with security lock activated by the double control on the doors locking
wire, this function can generally be activated only with med software.
9
Содержание MED 6000.LW
Страница 19: ......
