PROGRAMMINGS
program USER / VEHICLE functions
pair / test / delete wireless sensors
The system can be customised or wireless sensors can be added through programming.
To enter into the PROGRAMMING mode:
With doors, bonnet and boot closed, turn the ignition key
and
once to switch
the LED ON.
During the
in which the LED is lit, start to briefly press the LED button to:
-
consecutively (
).
Confirmation:
short, low tone BEEP of the buzzer, followed by a very long BEEP and by some
LED flashings. When the LED is fixed, we are in the programming phase.
-
(
).
Confirmation:
short two tone BEEP of the buzzer, followed by some BEEPS combined with
some LED flashings. When the LED is fixed, we are in the programming phase.
Every time the led switches OFF for confirmation and the buzzer of the siren gives 1 BEEP.
-
If the LED switches off autonomously within 2 or 3 seconds, wait for 30 seconds and repeat
the procedure again from point 1.
With the LED lit fixed press its button as many times as the chosen programming (consult the
relevant tables on the pages that follow).
-
On every valid pulse the LED switches off temporarily and the buzzer gives 1 BEEP.
Once terminated the sequence, after some seconds the system signals the programming
has been accepted giving a two tone signal, a series of BEEPS or a musical sequence and
the LED is now lit fixed again.
-
Short BEEPS and very quick flashings of the LED indicate a denial: the made programming
does not exist.
End the procedure, switch the ignition key
and
once.
The procedure can be started only if the system is desactivated.
Once entered into the programming mode it is possible to set up in succession more functions
belonging to the same category.
The completed and confirmed programmings remain active also when the central unit is not
fed.
The installer can select the vehicle “to be loaded” into the central unit to interface the original
system (line) and make all the
programmings by
means of the special SK KIT and a Personal Computer (office or laptop), using the specific
MED SOFTWARE,
or following versions.
1
[+15] ON
OFF
2
2 seconds
11 times
12 times
WARNING:
Pressing the LED button the BEEP of the buzzer confirms the signal has been
recognized by the central unit.
3
4
5
[+15] ON
OFF
WARNING:
program USER / VEHICLE functions
4.5
!
!
!
!
7
Содержание MED 6000.LW
Страница 19: ......
