mecalac AX 1000, Руководство по эксплуатации, Страница: 82 / 144

P0700/P0710/P0850/P0860/P1000/P1010 8-16
8 Maintenance
Figure 8-38
Figure 8-37
8.2.16 Maintaining/replacing the fresh air filter
NOTE
The fresh air filter is located in the driver’s cabin
underneath the seat plate.
(1) Tilt the backrest of the seat completely forward
(5-9/4).
(2) Loosen the four screws (8-37/arrows) holding the seat
plate.
(3) Pull or tilt the driver’s seat with the seat plate all the way
forward.
(4) Remove the filter cartridge (8-38/arrow) and clean it
using “mild” compressed air.
CAUTION
Do not use any petrol, hot fluids or industrial
compressed air for cleaning.
(5) Check the filter element for damage.
NOTE
The filter element must be replaced when it is
damaged (check
every 500 operating hours ),
but at least every 1500 operating hours.
(6) Insert the filter element, push the seat plate into the
assembly position and secure again.
8.2.17 Checking/adjusting the service/
parking brake
DANGER
- Check the combined service/parking brake
every 500 operating hours and adjust it if
necessary (see repair instructions).
- All work on the brake system must only be
carried out by authorised personnel.
- Oil loss (leaks) in the brake system must be
immediately reported to authorised personnel.
- Operation of the loader must be stopped imme-
diately if the pedal can be pressed down too far
or the braking effect decreases noticeably.
(1) Check the fluid level on the compensation tank for
brake hydraulic oil (8-39/arrow) and top up brake hydraulic
oil if necessary.
(2) Check the pedal travel.
(3) Check the entire system for proper functioning and
absence of leaks (visual test).
Figure 8-39