Mec 34-J Diesel, Руководство по обслуживанию и запасным частям

Страница: 108 / 272

Page 102 34-J Desel - Servce & Parts Manual
December 2021 Secton 19 - Troubleshootng
EZ-Cal Messages
“Help Messages” will appear on the EZ-Cal scan tool as a means of explaining operating and non-
operating function(s) and system errors or interruptions that are accompanied by flash codes. It can
also be used for verifying system operation. Refer to the EZ-Cal Instruction page for additional help
with EZ-Cal operation.
To access messages, power the system up, (it is not necessary to have the engine running) the EZ-
Cal display will illuminate and read “HELP - PRESS ENTER”. Press ENTER to view current message.
Press ENTER a second time then use right and left arrow buttons to access up 30 logged messages
from the memory. Many messages simply detail operations being performed by the GP500;
other messages detail occurrences that also take place during operation either normal or may be
symptomatic of a malfunction.
Operational Messages
The following messages appear as result of normal operation and usually do not represent a problem.
EVERYTHING OK________________________________ Flash Code: None
All circuits performing properly, no current operation performed.
GROUND MODE ACTIVE__________________________ Flash Code: None
Base/Platform selector switch set to base control station.
STARTUP_______________________________________ Flash Code: None
GP500 performing start up procedure, normally a short sequence.
MOVING FRAME_________________________________ Flash Code: None
Chassis level in progress.
MOVING PLATFORM_____________________________ Flash Code: None
Platform level in progress.
TELESCOPING__________________________________ Flash Code: None
Boom extend/retract (telescope) in progress.
LIFTING________________________________________ Flash Code: None
Boom lift up in progress.
LOWERING_____________________________________ Flash Code: None
Boom Lower down in progress.
DRIVING_______________________________________ Flash Code: None
Drive forward or reverse in progress.
VEHICLE TILTED________________________________ Flash Code: None
Chassis is tilted beyond pre-set maximum. Use auto-level feature to level chassis or re-position
the machine.
•
•
•
•
•
•
•
•
•
•