Mean Well RKP-1U-CMU1, Инструкция по эксплуатации

Страница: 4 / 43

0. Safety Guidelines
1. Introduction of Series Models
RKP-CMU1 / RKP-1U-CMU1
Instruction Manual
1.1 Introduction
1.2 Features
1.3 Order Information
◎
Risk of electrical shock and energy hazard. All failure should be examined by a qualified technician. Please do not remove the
case from the unit.
connected to earth ground. The total leakage current of the whole system, including two RCP-2000 units, is less than 2.3mA.
◎
Please do not change any component on the unit by yourself or make any kind of modification on it.
◎
Please do not install the unit in places with high moisture, high ambient temperature or under direct sunlight.
◎
Please do not feed in voltage that is over or less than 10% of the rated value. Refer to the safety label on the unit.
◎
The safety protection level of this unit is class I. As a result, the "Frame Ground" ( ) on the rear of the rack unit must be well
◎ 1U low profile/19-inch rack mounting.
The RKP-CMU1 is a dedicated monitor unit for Rack Power series with PMBus interface. It provides the management task of
RCP-2000 for using in telecommunication, monitoring systems, servers, etc. It can be stand-alone operated or integrated into a
19-inch rack.
◎ Control and monitor rack power units.
◎ Front panel LCD and buttons for on-site service without PC.
◎ USB, RS-232, or Ethernet interface for PC connection locally or remote monitoring and control via GSM modem.
◎ Alarm/event log with time and date.
◎ Windows-based PC communication software.
◎
Easy wire connections on rear side.
◎
4 user programmable relay outputs for traditional remote monitoring or warning.
◎
3 years warranty.
◎
Please refer to the safety label on top of each unit before operating (Figure 1-1~1-3).
Figure 1-1 Safety Label of RKP-CMU1
◎
Single unit :
1.3.1 Explanation for Encoding
1.3.2 Marking
1
Single unit : RKP-CMU1
1U rack : RKP-1U -CMU1
RKP-6K1U
Whole system (2*RCP-2000 + 1*RKP-CMU1 + RKP-1U
□
):
-
I
I CMU1- 12
Output Voltage
I : IEC320-C20 AC Inlet
I : IEC320-C20 AC Inlet
T : Terminal Block
T : Terminal Block


 




,



Please pay attentions when choosing rack power! RKP-CMU1 with new and old firmware revisions supports a variety of
PSU models with specific firmware revisions as shown in table below.
RKP-CMU1 Firmware Revision
R2
.
0
R1
.
1
PSU Model and Firmware Revision
DRP
-
3200
,
R1
.
0 and later
RCP
-
1600
,
R2
.
0 and later
RCP
-
2000
,
R2
.
0 and later
RCP
-
2000
,
R1
.
9 and prior
1.3.3 Model of Rack Powers supported by RKP-CMU1