Mean Green Products CXR-52"/60" ZTR, Руководство оператора

Страница: 45 / 52

44
8. Do not use with defective cords and wires. Replace defective cords and wires immediately.
Battery Charging Procedures and Options
LEM48140 lithium modules – approximate weight of 109-120 lbs.
WARNING: Batteries should not be removed from unit unless repair is needed. Use EXTREME
Caution When Lifting Batteries Out Of Mower Unit. Serious Injury to operator and/or Battery Could Occur
If Battery Is Mishandled or Dropped!!
WARNING: Do Not Use An Extension Cord To Charge Mower! If an extension cord must be used, it
must have a minimum of 10 AWG wires and be of the shortest length possible (10-25 ft long). Never leave
any cords coiled as excessive heat can build up and melt insulation of extension cord wires!
Chargers include: LEMC3548 (Standard Charger)
See separate guidelines for each below!
The charger will charge from a Standard 110-120V outlet at 25 amps-48volts. This will be drawing around
13 amps from the 110-120V wall outlet. NOTE: It is recommended to have a dedicated circuit for charging!!
DO NOT USE extension cords with chargers (see above note)!!
To use chargers at 35 amps, you will need to connect to a 220-240 Volt outlet. This will allow the LEMC3548
to charge your mower at 35 amp-48V (standard). The charger will sense the 220-240 voltage change
automatically. This will require a certified electrician to change the 110-120V plug on the charger power
cord to the 220-240V plug. The charger will draw around 7 amps for the LEMC3548 from the 220-240V wall
outlet. DO NOT USE an extension cord with the chargers (see above note)!!!
Pictured below notice the charger has a fan on the top of unit for cooling and 2 cords
– 1 from the left side
and 1 from the right side. The cord with the RED Anderson Connector plugs into the charging port of the
mower and the second cord plugs into the electrical wall outlet. The charger also has a light on the front of
the unit
– RED indicates charging and GREEN indicates battery is charged.
Fig. S1