MDT Technologies SCN-RT2UP.01, Руководство пользователя, Страница: 9 / 57

Technical Manual Temperature Controller
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1 •
Tel.: +49-2263-
880 • Fax: +49
-2263-4588
• knx@mdt.de •
www.mdt.de
9
4
Channel 1 Heat alarm DPT 1.001 send Controller sends
state Visu, Display,
Diagnostic,
additio al stage…
Communication object is
shown when the alarms are
active.
5 Channel 1 External sensor DPT 9.001 receive Controller receives
external
temperature External
temperature
sensor Communication object is
shown when the parameter
i te al/e te al se so is
set at least to 10% external
sensor.
6 Channel 1 Setpoint comfort DPT 9.001 receive Controller receives
new setpoint Visu, Control keys,
Central operation
unit Communication object is
always shown when the
controller is active. A new
setpoint can be set via this
object.
7 Channel 1 Manual setpoint value
offset DPT 9.002 receive Controller receives
relative movement
of setpoint Visu, Display,
Control keys,
Central operation
unit Communication object is
shown when the parameter
setpoi t offset ia is set to
Byte.
8 Channel 1 Control value heating DPT 1.001/
DPT 5.001 send Controller sends
control value Heating actuator,
actuators Object is shown when the
controller is set to the heating
mode. DPT depends to the
controller settings.