Technical Manual Temperature Controller
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49
-2263-4588
• [email protected] • www.mdt.de
28
4.4.2.7 Operating mode after reset
The following settings are available at the ETS-Software:
Figure 10: Operating mode after reset
The following chart shows the dynamic range for this parameter:
ETS-text
Dynamic range
[default value]
comment
Operating mode after reset
Comfort with
parameterized set point
Standby with parameterized
set point
Hold old state and set point
Adjustment, which operating mode shall
be switched on after a bus power return
Table 23: Operating mode after reset
This parameter defines the operating mode, which shall be adjusted after a bus power return. The
controller can start with the comfort mode or with the standby mode. In both cases, the
parameterized set point will be
esto ed. B usi g setti g Hold old state a d set poi t , the
controller restores the old operating mode and the set point, which was active before the reset. It
must be pointed out, that the controller has no settings in its memory in case of an initial operation.
