MCZ MUSA 2.0, Руководство по установке

Страница: 35 / 64

ON
OFF
D
E
33
10-FIRST START-UP
Technical Dept. - All rights reserved - Reproduction is prohibited
GENERAL PRECAUTIONS
Remove any objects that may burn from the brazier (manual, various adhesive labels or any polystyrene).
Check that the brazier is positioned correctly and rests properly on the base.
The first start-up may not be successful as the feed screw is empty and does not always manage to load the required
amount of pellets in time to light the flame.
ELIMINATE THE ALARM CONDITION OF A FAILED START-UP BY POSITIONING THE OF THE EMERGENCY PANEL TO OFF FOR
ABOUT 20 SECONDS AND BRINGING SELECTOR “D” BACK TO THE REMOTE POSITION. REMOVE THE PELLET LEFT IN THE
BRAZIER AND REPEAT THE START-UP. (SEE “SAFETY DEVICES/ALARMS” PARAGRAPH)
Switch-on/off from the emergency panel
If the remote control is faulty or the batteries are flat, the product can be operated in safe mode via the rear emergency panel.
In this configuration, the stove can only operate in manual mode and with the possibility to choose between 3 power levels.
• SWITCHING THE STOVE ON WITHOUT THE REMOTE CONTROL
To switch the stove on move selector “D” to the ON position. The RED LED goes off upon start-up, while the GREEN LED starts to flash until
the start-up stage is complete. Once the product is in steady state, the GREEN LED remains on.
• CHOOSING THE POWER WITHOUT THE REMOTE CONTROL
One can choose between 3 heating powers:
MIN-MED-MAX (seletctor “ E ”)
The MINIMUM power corresponds to the 1
st
power;
The MEDIUM power corresponds to the 3
rd
power;
The MAXIMUM power corresponds to the 5
th
power;
• SWITCHING THE STOVE OFF WITHOUT THE REMOTE CONTROL
To switch the stove off move selector “D” to the “OFF” position.
Once the remote control is restored, remember to set selector “D” back to the “REMOTE” position, otherwise the
product will ignore the remote control commands.