McElroy Hornet XL ASW31401, Руководство оператора

Страница: 15 / 34

Gener
al
Information
3 - 4 General Information Hornet™ XL
Attach Drill to Drill Adapter
1)
Attach the required socket to the socket adapter to
make up the length 4-7/8" between the end of the drill
pilot and the end of the socket.
The socket adapter with deep socket length is
3-13/16" (97mm).
The socket adapter with short socket length is 2-5/8"
(67mm).
2) Insert the adapter and socket into the drill chuck. The
amount of adapter inserted into the chuck will need to
make the total measurement from the end of the drill
pilot to the end of the socket to equal 4-7/8". Tighten
the drill chuck.
3) Insert the drill into the drill adapter. If the drill pilot
is 1-13/16" (46mm), then the drill sleeve must be
inserted into the drill adapter so that the drill adapter
can be tightened to the drill pilot. Align the slot on the
drill sleeve with the slot of the drill adapter.
4)
Ensure the drill is fully inserted over the drill pilot of the
drill. If the drill will not insert completely, you may need
to adjust the socket adapter. Tighten the drill adapter
clamp.
5) Check the function of drill by pressing the trigger. The
chuck of the drill adapter should turn when operated.
If the drill adapter does not turn, remove the drill and
extend more of the socket adapter.
IMPORTANT:
Dedicating a drill to the drill adapter will
defeat the need to remove and reattach the drill adapter to the
drill. Leave the drill attached and store it in the Hornet XL case.
CD02431-02-18-19
CD02433-02-18-19
CD02430-02-18-19
CD02434-02-18-19
CD02435-02-18-19
Drill Pilot
Drill Chuck
Drill Sleeve
Drill Adapter
Tighten Clamp
4-7/8"
End of Socket
End of Drill Pilot
Socket
Socket Adapter
Drill Sleeve - Only used
for a drill pilot size of
1-13/16" (46mm)
4-7/8"