CartPark Architectural |
Page 9 of 11
13
Installing the retainer
From the outside of the unit, slide the retainer onto the outer edges of the roof panels. Make sure that the
retainer is flush with the front and back of roof frame assembly. Secure the retainer to roof frame with 7,
#14 x ¾” Pan Head torx type F selftapping screws as shown in detail A. Repeat step to install the other retainer.
14
Retainer
Flush
Roof panel
Outer edge
Customer logo
Facing out
bottom aluminum
support
aluminum
shoulder
spacer
Tri-glass Panel
Peel off the protective film from both sides of the tri-glass panel. Locate one tri-glass panel onto the front of the
unit so that its flush with the top perimeter of roof line. Secure tri-glass panel to roof frames with, 8 ¼-20 x 1.0”
Pan head Taptite screws coated with wax, and 8, ¼” ID x ⅜” long aluminum shoulder spacers. Slide aluminum
bottom support onto bottom of tri-glass panel until both holes are aligned with frame. Secure aluminum bottom
support with 2, ¼-20 x 1.0” Pan head Taptite screws coated with wax, and 2, ¼” ID x 3/8” long aluminum shoulder
spacers. From the inside of the unit, secure each bottom support to tri-glass panels with 2, #10-32 x ⅜” Phillips
Head screws as shown. Repeat for additional tri-glass panels.
Repeat for additional
tri-glass panels.
